Ableton Forum

Since day 1 I observe the following issue with Push 3 in controller mode:

1. multiple tracks
2. (expected behaviour) active track highlights played notes with green lights, device parameters can be changed with encoders in device view
3. switch to another track using lower display buttons
4. issue: played notes will not be highlighted anymore for active track, encoders modify parameters of last track, but not the current active track

System: Push 3 with firmware 1.4.4, macOS Sonoma 14.4.1, Live 12.0.2 and 12.0.5b4

I am quite confident, that this is an issue of the controller integration, because scope to another track will be correctly reflected on Push, if:
a) track is switched in Live
b) track is switched by another hw controller (e.g. AKAI APCmini MK2)

Can anybody else observe this issue?

Are you observing this with any set or only a specific one(s)?

Unfortunately, this is a general issue with any set.&

So, am I the only one with this annoying issue?

I have already opened a support ticket, but did not get any response. Is Ableton still investing in providing proper support to their products, that are not really on the cheap side?

Meanwhile support has replied and the cause is found: Although option „EnableArmOnSelection“ is a preferred choice with many hardware controllers, it's not compatible with Push 3 and a documented behaviour. Such a pitty,

This M4L device has an automatic track arming option.