Push 3 and noise interference
Posted: Tue Dec 24, 2024 8:30 pm
Hi there
I've been having problems with signal input quality on my P3S. I find that there is what sounds like RF interference - humming, crackling and other strange noises. It seems extremely sensitive to everything near it.
The worst offenders seem to be the P3S power supply - if it is plugged in, I get constant hum when monitoring, and also when I touch any controls - each control I touch will trigger a buzzing sound when I am monitoring.
I also find that the signal input carries noise and interference too. Some of this might be the gear that I use (I'm aware than single coil pickups are very sensitive, and I use some vintage gear such as tape delays which can also create noise) but I'm broadly familiar with different types of noise interference and this seems to be emanating primarily from within the Push.
Does anyone have any tips / ideas?
I've been having problems with signal input quality on my P3S. I find that there is what sounds like RF interference - humming, crackling and other strange noises. It seems extremely sensitive to everything near it.
The worst offenders seem to be the P3S power supply - if it is plugged in, I get constant hum when monitoring, and also when I touch any controls - each control I touch will trigger a buzzing sound when I am monitoring.
I also find that the signal input carries noise and interference too. Some of this might be the gear that I use (I'm aware than single coil pickups are very sensitive, and I use some vintage gear such as tape delays which can also create noise) but I'm broadly familiar with different types of noise interference and this seems to be emanating primarily from within the Push.
Does anyone have any tips / ideas?