Latency issue
Posted: Mon Jan 20, 2025 6:47 pm
Hi.. I have a external audio source (Roland SPD-SX Pro) connected to my Push 3 to the In audio ports...
On the Push 3 in Settings > Audio, I have:
Sample Rate: 44100
Buffer Size 2048
Link 1 & 2 : On
1&2 Preamp Type: High
Push 3 is going into Live 12 in controller (not Standalone) mode.. The Input is to a single stereo channel in an otherwise empty project. Monitor on the track is set to In.
I've noticed that if I let this sit for a while (not sure how long.. could be minutes.. hours).. When I tap a pad on the Roland, there can be a significant delay... however, if I adjust the buffer size down, then back up.. the delay is noticeably / significantly reduced... until I wait a wile again, then the delay is quite noticeable again.
What's going on? it seems as if the latency 'builds' over time.
On the Push 3 in Settings > Audio, I have:
Sample Rate: 44100
Buffer Size 2048
Link 1 & 2 : On
1&2 Preamp Type: High
Push 3 is going into Live 12 in controller (not Standalone) mode.. The Input is to a single stereo channel in an otherwise empty project. Monitor on the track is set to In.
I've noticed that if I let this sit for a while (not sure how long.. could be minutes.. hours).. When I tap a pad on the Roland, there can be a significant delay... however, if I adjust the buffer size down, then back up.. the delay is noticeably / significantly reduced... until I wait a wile again, then the delay is quite noticeable again.
What's going on? it seems as if the latency 'builds' over time.