Ableton Forum

Hi,
I use CC Control for external instruments and have given individual names to CC controls, like Cutoff, Resonance etc.

The moment I press enter, the new name shows up on Push 3 (Controler Version). When restarting either Push or Ableton, Push 3 doesn't show my individual label names, but rather the initial "Custom A" "Custom B" ..... is there anything I need to configure to have Push "reading " the saved names? All good inside the software, my names are stored.

Thanks - kind regards, Collin

SOunds like an initialisation routine on the device is failing, best to open a support ticket for that.
Cheers
D

+1 to S4racen's commment.
Also, as a workaround you can rack your CC Control and use the macros to label your stuff.

thanks - contacted support. weird thing is that when dragging the saved device into the track, labels show up again -just not at initialization as you pointed out