Ableton Forum

Hi everyone,

In my current project I want to solo a specific group, the drums in this instance, and even if the group is soloed, it still plays audio from the rest of the groups (bass, rhodes, vocals etc.)

I've checked all the routing to make sure the audio is going to its proper destination and all the inputs are set to no input to avoid any signal coming in. Return tracks are set to post.

The only issue is when I solo the drums group, with all the other groups the solo button behaves normally... I've been trying to wrap my head around this for hours, it's the only project where I encounter this strange behavior.

Can anyone help please?

Thanks

Did you try opening a new Set, and then drag'n'dropping your mentioned Set's groups into it from the Browser and try to replicate the issue?