Ableton Forum

What size screws are used on the Push 3?

I seem to have mislaid the 11x screws which secures the back of the Push 3 standalone, as well as the 3 x screws which secures the battery, and the 2x screws which secures the Module.

Does anyone know the size and length of screws used?. M3? or M4? and length would be useful.

Thanks.

You should definitely ask Support.

[jur] wrote: ↑

Sun Jul 05, 2026 8:06 pm

You should definitely ask Support.

I have just had the following reply from Support. Can anyone verify the 'length of threads on these screws?

"
Hi there,

Thanks for your email.

While I cannot find confirmed screws from what I can find the following should be appropriate:


Backplate (Perimeter Screws): M2.5 × 6mm Torx/Hex machine screws.
Backplate (3 Middle Screws): M2 × 4mm Torx/Hex machine screws.
Processor (Compute Element): M2 × 3mm flat-head machine screws.
Battery: M3 × 6mm pan-head machine screw.
Heatsink: M2.5 × 5mm machine screws (5 count).


Apologies for not being 100% on this, however I hope this helps,

Best,
Chris
"