Ableton Forum

hello i want to record some midi control messages that i use to play clips.
unfortunately it seems that if i select my midi input as remote, then arm a midi track and ask it to record all incoming midi, the midi is filtered out.
but if i unselect remote in prefferences, it reads my controller but does not launch the clips.

is there a way around this?

thanks


p.s.
i was just thinking i could usemidi ox to send out a duplicate midi message via midi yoke and only use it for recording and possibly even relaunching clips when im done.

i'll let u know how it turns out but if anyone knows how to do this without involving other programs i would apreciate it.

HMM
not the effect i had hoped for..
seems like i got too much loopback

bump...

works fine for me. make sure you have the midi controller set as a track input only and the midi yoke set as a track output and remote input. you'll get midi feedback if you route the midi back to itself and midiyoke/live will automatically disable that yoke till you rescan it in preferences.