Ableton Forum

when i assign a rotary to the GainLow (also mid and high) and set the range to max. 0db i cannot go down as much needed by rotating the rotary - setting the range to "normal" does make problems because then it is not possible to see if 0db are applyed because this thereafter will not be in middle of the rotary on the xsession and so unusable ...
any tip how to use the full range of the roary and having the 0 db in middle of the rotary range ?

did you try to select - 64 to +63 values for the rotary control on the X-Station ?

or use eq4 instead

did you try to select - 64 to +63 values for the rotary control on the X-Station ?

in ableton i can only select from -x to +6 - should i set something on the x-session controller itselfe ? but the problem will still be that there is no possibility to have the rotary knobs on the x-session in middle settings because it does not correspond to the gui in ableton...

eq4 - how to use it with x-session midi interface

i only have uc33e not x session but I imagine it's the sam to asign the knobs, you can set eq 4 up as a 3 band eq if you want as far as i can see it would do the same thing except when the knob is cetered so is the eq