LoadsaLittleGlitches4AbletonToLookAtBefore6
Posted: Mon May 08, 2006 7:31 pm
I have been keeping a note of all the little glitches,
Most of these are not big problems, more graphics glitches.
So anyway I hope ableton look at them in the next maintanance update.
Graphic glitches - On a powered off instruments power button.When a set is loaded that contains instruments which are off, the power buttons flicks on/off as you are moving through the channels. This happens once everytime per loaded set.
Also the clip envelope button shows the wrong state sometimes. I noticed I must deselect it and then select it again for the clip envelopes to appear, even though it indicates the envelope mode is selected.
After recording a new clip it showed a envelope view (ie clip all highlighted red in the display) but the envelopes display was not selected so it should have shown the normal view of the waveform (I think?)
That Wrench/Spanner (Open GUI Button) glitches all the time when loading or deleting instruments.
And finally the biggest problem with Live 5 for me is ...
Clips don't trigger with very great accuracy during sets, you could easily mess up while playing live because the program isn't responding in time. Often after you have pressed play there will be a long pause before the clip plays and it misses the cue. Live...not a chance.
Most of these are not big problems, more graphics glitches.
So anyway I hope ableton look at them in the next maintanance update.
Graphic glitches - On a powered off instruments power button.When a set is loaded that contains instruments which are off, the power buttons flicks on/off as you are moving through the channels. This happens once everytime per loaded set.
Also the clip envelope button shows the wrong state sometimes. I noticed I must deselect it and then select it again for the clip envelopes to appear, even though it indicates the envelope mode is selected.
After recording a new clip it showed a envelope view (ie clip all highlighted red in the display) but the envelopes display was not selected so it should have shown the normal view of the waveform (I think?)
That Wrench/Spanner (Open GUI Button) glitches all the time when loading or deleting instruments.
And finally the biggest problem with Live 5 for me is ...
Clips don't trigger with very great accuracy during sets, you could easily mess up while playing live because the program isn't responding in time. Often after you have pressed play there will be a long pause before the clip plays and it misses the cue. Live...not a chance.