Page 1 of 1
it sounds like my tracks sound louder out the right speaker
Posted: Tue Jul 18, 2006 10:59 am
by poops
Yea, ive been trying to figure it out. It is very noticeable. Everything is hooked up great. But inotice my rendered tracks compared to other tracks in my itunes sound like there is more sound coming from the right speaker.
Does that make sense?
Other tracks in my itunes, even tracks there made at my buddies on his computer do not sound this way. But the ones I have made here on my computer have a shifted balance in the sound. Its liek the right speaker is puching the sound more than the left.
Has anyone else ran across this problem who can help me?
I know its not my speakers, and i know its not my sound prefs on my computer, and everything else seems fine.
What could it be?
Re: it sounds like my tracks sound louder out the right spea
Posted: Thu Jul 20, 2006 6:27 am
by microgroover
poops wrote:Yea, ive been trying to figure it out. It is very noticeable. Everything is hooked up great. But inotice my rendered tracks compared to other tracks in my itunes sound like there is more sound coming from the right speaker.
Does that make sense?
Other tracks in my itunes, even tracks there made at my buddies on his computer do not sound this way. But the ones I have made here on my computer have a shifted balance in the sound. Its liek the right speaker is puching the sound more than the left.
Has anyone else ran across this problem who can help me?
I know its not my speakers, and i know its not my sound prefs on my computer, and everything else seems fine.
What could it be?
I've noticed that when using the autofilter, it seems to shift the audio to the right (filtering seems to occur faster on the left channel). Has been especially audiable when using a highpass filter.
Posted: Thu Jul 20, 2006 6:46 am
by hoffman2k
Check system prefs.
Sometimes the panning will be off center, not sure what causes it.
Posted: Thu Jul 27, 2006 6:10 pm
by poops
naw, its still the same way, im not sure what it is.
Posted: Fri Jul 28, 2006 12:47 am
by redrabbit
Do you have another application that will tell/show you a dB level reading in an "averaged" way ? ...so you can check a finished, rendered file.... to be sure?
I know Wavelab will, SoundForge, etc.
A free one would be Voxengo Span....I forget but ..set it to Averaged..note the readings on Right channel, then Left channel.
http://www.voxengo.com/product/SPAN/
=RR=
Posted: Sat Jul 29, 2006 6:33 am
by poops
thanks for the advice, im looking into one for mac.
peace