Ableton Forum

I have the darndest annoying bugs using RMIV in Live 5. They are to do with changing the currently selected pad - odd things happen:-

Changing knob/slider on a non-selected pad
The first time you drag a knob on a pad which is not the currently selected one (with the green light next to the pad name) the knob jumps back to its original value. After that the green light displays that this pad is currently selected and then everything works OK.

Filter setings for pad 1 get another pad's settings
If I have filter settings on the currently selected pad and then select pad 1, pad 1 doesn't sound right because the filter settings are the ones from the previously selected pad. Everytime. Mostly isn't a problem as the filter is usually disabled, but I can reproduce this over and over again. Only happens when changing to pad 1, none of the other pads...

These are so consistent and on several of my well maintained computers that I can't believe I'm the only one. Can anyone confirm it on theirs, or is it perfectly fine for you?

Cheers,
B

i'll check it out later.

Bump

Anyone? I can't use RMIV with this annoying behaviour. Does it work for anyone else with Live 5?

Thanks,
B

I experience the same problems with RMIV and Live 5.

I'll check it in Live 6 later today. Does RMIV not exhibit this behavior in other hosts?

RMIV can be great - it works perfectly for me in the Orion demo so I'm not just an RMIV hater. I really want it to work in Live 5.

Thanks for confirming.

Cheers,
B

LivePsy wrote:
Changing knob/slider on a non-selected pad
The first time you drag a knob on a pad which is not the currently selected one (with the green light next to the pad name) the knob jumps back to its original value. After that the green light displays that this pad is currently selected and then everything works OK.

This problem is still present in Live 6b4.

LivePsy wrote:Filter setings for pad 1 get another pad's settings
If I have filter settings on the currently selected pad and then select pad 1, pad 1 doesn't sound right because the filter settings are the ones from the previously selected pad. Everytime. Mostly isn't a problem as the filter is usually disabled, but I can reproduce this over and over again. Only happens when changing to pad 1, none of the other pads...

This problem is also still occuring. If I have Pad 1 selected, with no filter on, and then select another Pad that has filter settings - those settings are copied to Pad 1.