Problem: Out of time and snowblind ;)
Posted: Sun Dec 03, 2006 9:26 pm
Hi @all,
I have a very strange problem, my clips timing start to get displaced after some not so certain time. I have them all in loop mode, all the same langth(8 bars) and all the same measure(4/4). After maybe the 2nd loop right in the middle of the loop the yellow dot appears and starts its slow journey from the left to the right.
I'm not too much of a power user, so I might be missing the obvious, but I am pretty sure that this behavior is new. I checked all the start-endpoints, looplengths triggermodes but I just can't figure it out. I run reason as a rewire slave, use reaktor vst and operator. Reason completely looses sync when this occures and starts being all over the place.
And, to completely drive my nuts, I wanted to render an example 4 u to listen 2, but this just didn't happen when rendering. It only happens umhh live.
Btw, I'm using live 6.0.1 on a core duo laptop, m-audio oxygene 8, behringer bcf2000 in mackie mode, m-audiofirewire audiophile.
Help, ideas and suggestions extremely appreciated for I'm completely stuck
Regards
wolfgang
I have a very strange problem, my clips timing start to get displaced after some not so certain time. I have them all in loop mode, all the same langth(8 bars) and all the same measure(4/4). After maybe the 2nd loop right in the middle of the loop the yellow dot appears and starts its slow journey from the left to the right.
I'm not too much of a power user, so I might be missing the obvious, but I am pretty sure that this behavior is new. I checked all the start-endpoints, looplengths triggermodes but I just can't figure it out. I run reason as a rewire slave, use reaktor vst and operator. Reason completely looses sync when this occures and starts being all over the place.
And, to completely drive my nuts, I wanted to render an example 4 u to listen 2, but this just didn't happen when rendering. It only happens umhh live.
Btw, I'm using live 6.0.1 on a core duo laptop, m-audio oxygene 8, behringer bcf2000 in mackie mode, m-audiofirewire audiophile.
Help, ideas and suggestions extremely appreciated for I'm completely stuck
Regards
wolfgang
