Page 1 of 1
Animating device ON/OFF directly possible?
Posted: Fri Dec 22, 2006 2:15 am
by posssu
If I have some devices in my rack, I can't directly animate the on/off-button state, but I must assign them to macro controls and then animate those controls.
Posted: Fri Dec 22, 2006 2:34 am
by longjohns
you can automate the device on/off in the arrangement view, but not in session clips. that seems to go for both FX within and outside of a rack
Posted: Fri Dec 22, 2006 4:19 am
by posssu
Yea. I would need the automation in the clip view, since I use clips to toggle gig sounds on and off.