Ableton Forum

Hello,
I have a project I made in Live5 on my PPC Imac G5. When I load it up in MBP I get a distint "pop" when it first loads. Each channel shows audio, but the master bus doesn't have audio playing through. When I close the project I again hear a distinct pop and audio works.

It's all generative based works, no samples.

Commercial Plugins
--------------------
- uTonic
- Filterscape
- 3 Instances of Zebra 2
- Phase Two

Ableton Plugins
---------------
- Redux
- Saturator
- Auto Filter
- Simple Delay


Any ideas? I've tried removing individual plugs, but it seems like once it pops, it stays in that state. I can still use it on my G5, but I'd prefer to write and work on my MBP.

Just have to ask: What version of LIVE are you on? It isn't clear from your post, but all versions prior to 5.2 will not work well at all on the new intel Macs. That is because all versions prior to 5.2 are not Universal Binary, and will have to work under rosetta, which will be dog slow. So you may have to upgrade to 5.2.

Best,
AB