Page 1 of 1
Program sounds to axiom
Posted: Tue Jan 16, 2007 1:46 am
by drgonzo1069
I am a new user of abelton, i was woundering if there was a way to program the sounds you make in Live onto the Axiom 49? If so then how?
Posted: Tue Jan 16, 2007 1:50 am
by astroid
no
the axiom only sends midi
Yet another
Posted: Tue Jan 16, 2007 1:58 am
by drgonzo1069
So the
Program button, Data1 2 and 3, Chan Assign, CTR assign,store , and snap shot buttons are used for what?
Posted: Tue Jan 16, 2007 2:24 am
by Clearscreen
So the Program button, Data1 2 and 3, Chan Assign, CTR assign,store , and snap shot buttons are used for what?
setting up how the axiom sends midi. it can't do any audio - it controls other stuff that makes the actual sound (like live for example).
yet again
Posted: Tue Jan 16, 2007 2:32 am
by drgonzo1069
So how do you get it to control the sound or program it so it can play if you bring it to another DAW.
Re: yet again
Posted: Tue Jan 16, 2007 2:41 am
by hacktheplanet
drgonzo1069 wrote:So how do you get it to control the sound or program it so it can play if you bring it to another DAW.
Depends on what you're trying to play. If you have a software synthesizer, then you can probably open up the patch you made in another DAW, and play it there. If it's a sample, you will probably have to load your sample into another sampling instrument in the other DAW.
The Axiom is just a MIDI controller. It just tells soft/hardware what to do. It's up to the soft/hardware to do it.
Posted: Tue Jan 16, 2007 2:43 am
by Clearscreen
have a look at the live manual - you need to route the midi from the axiom to stuff in live. if you have the drivers installed properly the axiom should show up as an available midi controller in the live preferences (on the bottom of the options menu). then have a look at the live manual for routing the midi into live and setting up midi assignments.