Ableton Forum

Hi

I've got the Access Virus TI Polar and updated it with the latest firmware etc. and ditto for Live.

I've noticed that often when I've got a patch loaded with an arp the BPM light on the Polar will suddenly start flashing at a MUCH slower rate than it should and indeed, when I press a note the arp is w-a-y t-o-o- s-l-o-w.

...then later it will sync back in to Live of it's own accord!!!

Has anyone else had this and fixed it?

Check out the VirusTi.com forums, it's a known issue and Access is working on it.

TheProdigy wrote:Hi

I've got the Access Virus TI Polar and updated it with the latest firmware etc. and ditto for Live.

I've noticed that often when I've got a patch loaded with an arp the BPM light on the Polar will suddenly start flashing at a MUCH slower rate than it should and indeed, when I press a note the arp is w-a-y t-o-o- s-l-o-w.

...then later it will sync back in to Live of it's own accord!!!

Has anyone else had this and fixed it?

Hey Prod,

I get that problem ALL the time man it can be a right pain in the arse when your in the middle of making a quality tune and it all goes tits up on you!!

My work around is save what you just did, and then jst reload the song. It doesn't take that long to load and when your virus configures itself its all usually running sweet again..... well...... until the next time of course!

Ben

Hi Liam,
Is it you btw?
Well on the sync issue there is a temp solution on the Virus forums.Check it here: http://virusti.com/forum/index.php?s=1f ... 2246&st=30
Also try not to pass that 60% of cpu usage cause things are getting nusty after that.I work with VC v.2.0 for production stuff and when i wanna go live just use that SPDIF's with midi...

Yorgos