Auto Filter Engage Issue Resolved
Posted: Sat Dec 13, 2003 3:43 pm
OK, my problem only existed upon 1st play though of my song and when rendering (big problem). Once I played through the measure where the problem existed...it didn't happen again even if I play through the effected measure over & over.
Setup of the Track: Auto Filter is on for the duration of the entire song. I'm automating Freq & Res (only). The automation did NOT start until 8 measures after the clip starts.
The Issue: Sounded like the Freq is going from low to high within the first .2 seconds of the beginning of the clip. Sounded really bad.
I tried toggling between Ram & Disk mode...no difference. If I turned the Auto Filter off, then the problem goes away...but, I don't want to delete it. I had to automate the quantize off...then on just before my other automation to get it to stop doing that. I should not have to do that....took me a damn hour to figure that out. Thought I'd share the pain.
Anyway...still think Live is the best software I'm using.
Setup of the Track: Auto Filter is on for the duration of the entire song. I'm automating Freq & Res (only). The automation did NOT start until 8 measures after the clip starts.
The Issue: Sounded like the Freq is going from low to high within the first .2 seconds of the beginning of the clip. Sounded really bad.
I tried toggling between Ram & Disk mode...no difference. If I turned the Auto Filter off, then the problem goes away...but, I don't want to delete it. I had to automate the quantize off...then on just before my other automation to get it to stop doing that. I should not have to do that....took me a damn hour to figure that out. Thought I'd share the pain.
Anyway...still think Live is the best software I'm using.