Ableton Forum

Hello -

I am happily using Live 3, but have had nothing but trouble using Live with the M-Audio Ozone. This all happened during a week with 2 live gigs, one of which used the Ozone extensively.

I'd set everything up, run fine for a while, and then either the Ozone would refuse to pass audio, MIDI or both to or from Live 3. During one rehearsal the whole shebang crashed, and trashed Live to where it wouldn't boot, and I had to re-install and start over.

I am running:
Live 3.0 on a 667MHz Titanium laptop, OS 9.2.2 with 768MB RAM
M-Audio Ozone drivers v1.5.1

I am running this by M-Audio too. It seems odd that this combination would cause trouble.

- - -

Heather Perkins
Composer & Sound Designer
WaterDog Studio
http://www.waterdogstudio.com

Hi there,

I've only had the Ozone for a couple of weeks, but i've had no major problems with it to date. Did this problem suddenly occur or only upon your usage of Ozone with Live 3? I can't remember where i saw it, but this other bloke on the forum had tons of problems with his first Ozone, but everything was solved when he got a new one. Not exactly a problem solving reply, but it might give you indications as to the direction to look at.

I'm using:
Live 3.0
Tibook 1Ghz, 512mb RAM
OS X 10.2.8

Cheers,
Dk