Page 1 of 1
Automation curves
Posted: Thu Jun 14, 2007 9:18 am
by Idonotlikebroccoli
The following could have been done in an instant if there were automation curves available. Imagine what a timesaver it would be. And the experimenting and practical things. And of course that probably every other DAW has them.
Posted: Thu Jun 14, 2007 5:48 pm
by nagal
+1
it would be nice to actually have curve tool over just straight lines between nodes.
You would be surprised what DAWs dont actually have curves [cough]Cubase[cough]
Posted: Thu Jun 14, 2007 7:43 pm
by Martyn
+1
not having the automation round down so much after recording would be good too. It drives me nuts how much automation detail is simply thrown away, audibly so.
Posted: Wed Jun 20, 2007 9:20 am
by sporkles
I totally agree - in fact, I was going to ask just now: Where the hell can I edit my controller automation?
Posted: Wed Jun 20, 2007 12:14 pm
by borg
yes, nice curves