Ableton Forum

I recently reformatted my MacBook and just reloaded Live and all of my audio goodies. I hooked up my Trigger Finger and started playing with it and noticed that for the first time the control knobs and faders worked properly - when I used them before I used to have to manually map them which was a bummer because I know that there are presets already mapped to Live. Today I got it out and started playing with it and sure enough, the faders and knobs no longer work. The only thing I've changed was that I added an Oxygen8v2 to the computer. Other than that everything is the same. The knobs on the Oxygen work fine.

Anybody have any suggestions? When I turn a knob on the TF the little box in the top right of the toolbar lights up but the one between midi and key doesn't like it does when I use the Oxygen. Please help, this is driving me nuts...again. Thanks!

The presets for Live on the TF are 10 and 11. If I change my presets to either 1 or 2 I get the use of my controls but then my pads are no longer mapped to the right presets for live. Any suggested work arounds for getting the pads knobs and faders to all work on the same preset?

Use preset 10. Receive 8 pads from channel 10 and 8 from channel 11.
You can use 2 MIDI tracks to do that.

Thanks - I understand that but I still have the same problem - when I use preset 10 my knobs and faders aren't premapped and don't work unless I manually map them - I was trying to figure out a way to use my presets AND have my faders and knobs premapped. As it is they are only premapped on preset 1 and 2. Any other ideas?