Ableton Forum

Hello ppl,

I am having some problems with clicks and pops on low sine wave bass sounds in Simpler and was hoping someone would have some advice on how to eliminate this. I've adjusted the loop/snap/fade points and set a slow attack and long release but am still plagued by the pop at the begining of the sample. Any sugguestions are appreciated.

Cheers

Click/pop @ start of sample: start the sample at a zero-crossing point.

NOT the loop start, but the sample start.

But since you say adjusting the sample start time and/or fade-in's dont help... maybe the problem is in your filter. Are you using a resonant filter or something? Raise the attack on your filter.