Page 1 of 1
fixed!
Posted: Thu Jan 17, 2008 11:59 am
by timothyallan
mapping my bcr2000 absolute 1-127 knob to the scene scroll is wacky.
It gets to 64ish and then the cursor jumps right back to the top again. I can't ever scroll down past the middle.
It's also detected as absolute, not 2's comp or anything.
Works fine in 7 release.
Posted: Fri Jan 18, 2008 9:03 am
by timothyallan
doesnt work in b3 either
Posted: Fri Jan 18, 2008 10:01 am
by timothyallan
there was a button on the bcr with the same CC#. When I'd scroll past 64, the button would fire as well, causing the scroll lline to jump back to the top.
Weird that it doesn't do it in 7, bue either way, user error!
Posted: Fri Jan 18, 2008 11:02 am
by jab
Hi timothyallen,
just to understand what happened:
Was the button with the same CC#
mapped to something else?
cheers,
Jan
Posted: Fri Jan 18, 2008 11:45 am
by timothyallan
yes, the button was mapped to track select (top) and clip select (beside the track stop button). The only reason I noticed this was that when i turned the scene scroll knob past 64, the select LED would light up on the bcr.