Page 1 of 1
Apogee Symphony Advanced Routing Problems
Posted: Sat Feb 09, 2008 1:37 pm
by rhawtin
Hello. I'm running a rather large Apogee Symphony System and using the Apogee Advanced Routing Mode. Is anyone else out there running any type of Advanced Routing Mode with this type of Hardware, and if so, are you able to see all the extra channels? Currently I'm only able to access the analog channels from Ableton, and not any extra Advanced Digital IO
... even though in my Audio/Midi setup everything is there?!
Any help would be greatly appreciated.
Thanks.
Rich
Posted: Sat Feb 09, 2008 1:47 pm
by hoffman2k
Have you activated all I/O's in the Audio preferences?
Posted: Sun Feb 10, 2008 12:03 am
by ngwese
I am using a Symphony system with 1 x AD-16X and 1 x DA-16X, both in advanced routing mode, 8 channel VBUS, and Live 6/7. I never had problems seeing the all 40 inputs and outputs in that configuration (assuming they were all enabled in Live's audio preferences).
The one thing which hasn't worked (and I've not spent time debugging it) was sending audio between Max/MSP and LIve using the VBUS channels (lots of clicks and pops).
Re: Apogee Symphony Advanced Routing Problems
Posted: Wed May 11, 2011 10:27 am
by FrancisBegbie
Does anybody know which settings are necessary to use vbus. I would like to route a standealone instrument into Live via vbus. I have activated vbus in the maestro control window but it doesn´t work. Who can help me?
Many thanks in advance!