Page 1 of 1
reaktor
Posted: Wed Jan 09, 2002 4:53 pm
by IZNODJ
is it possible to have reaktor or absynth rewire in live the same way that i do it with reason? :roll:
Posted: Thu Jan 10, 2002 10:15 am
by Ableton admin
sorry no. there is no xxx to rewire modul available on the market. but if you are using direct-x on a pc you maybe can start both programm on different outputs and sync it via the midi sync signal. but this no a good solution, or? maybe we will write a tutorial about stuff like that soon.
best,
sven
ableton ag
absynth and reaktor in live
Posted: Fri Jan 11, 2002 9:00 am
by slip
Please do that. Live should be able to run vst instruents in the future.
God i wish absynth worked here. when could this be available?
Posted: Fri Jan 11, 2002 9:06 am
by Ableton admin
maybe not that long ..., but sorry
i cannot tell you our upcoming feature now.
sven
ableton ag
Posted: Sat Jan 12, 2002 7:59 am
by bsom
Right now, I'd be satisfied with sending MIDI clock/BPM to the effects until VSTi support is implemented....I have quite a few BPM-based effects that aren't getting used to their full capacity....
But, VSTi would rock!
reaktor->live
Posted: Sat Jan 19, 2002 4:12 am
by monolake
Even if this does not solve your reaktor->live problem i want to let you know that it is possible to use MAX / MSP as a rewire master and pipe in audio from there straight into live.
rob.
Re: reaktor->live
Posted: Tue Feb 18, 2003 10:39 pm
by claudek
monolake wrote:Even if this does not solve your reaktor->live problem i want to let you know that it is possible to use MAX / MSP as a rewire master and pipe in audio from there straight into live.
rob.
I just downloaded the "UglyVSTi v1.1 " and started the host and wondered
how is it posible to get the Reaktor going and audio via Rewire into
Live.I see the MAX Rewire Ext in live as a input source,but I cannot seem to get Reaktor to send midi clock to live and have Live Sync or vica versa.
I think when Reaktor is set as a VST Remote out all sync is off?
Any idas?