Ableton Forum

Can anybody help? The MPD-16 works until the next reboot after installing the driver.

Then I get the following message in the system.log: "PlugIn Akai_MPD16_USBMIDIDriver.plugin -- /Library/Audio/MIDI Drivers/ does not contain a supported architecture." Very strange.

Best regards
Mister M

The installation was ok but now it hangs live if I try to use the plug-in. Any ideas? It runs on OSX 10.4.10 on an Intel Power Book.

Thanks in advance
Mister M

Please give us the time signature change !

Hi all, any help will be kindly accepted! I've been reading the Bcf manual but aside from the various modes, it not clear how to cascade connect 2 or more Bcfs in mackie mode... I've got one connected so far, via Usb, in mackie mode. When i start Live, it works flawlessly. Now i'd like to add anoth...

paddypaws wrote:says it all in the subject.. i'd be fucking dangerous if i have subs in live

You can have Subgroups in Live. Route the concerning channels not to the master. use a In-channel for that instead. This in-channel is the new subgroup.

Best regards
Mister M, MKSoundlab

thanks for the replies. looking at those prices for the modules i decided to build them myself too. doepfer's core for 100 € is a LITTLE over priced. for 16 analog input channels you'd need maybe 2 analog multiplexers, a µC with an ADC, a DIN out connector, circuit board, wires, power. all this goe...

When i use the uad card in live 5, most of the time i get crackles, glitches in audio. Had it also in live 4. I had a bit of hope that in the upgrade to 5, the problem would be fixed. Must say that in 5 the glitches are reduced, but its not gone:( Ok. I used to have similiar problems with live 5 an...

Create a new audio-track. It is a good idea to rename it to "Sub 1".
Set Audio from of this track to "no input". Insert the compressor to this track.

For Track 1 and 2 set the "Audio To" to "Sub 1" (the name of your created track).

Best regards Mister M