Impulse and clip settings

conny · Post by **conny** » Sun Mar 13, 2005 10:11 pm

This was not obviuos for me:
When a clip in session is dragged to an Impulse slot, the settings start and end pos is regognized by Impulse. Meaning that the same sample, as different clips, with different start/end settings may be used in different Impulse slots.

// C

Sintec · Post by **Sintec** » Mon Mar 14, 2005 8:32 am

genius isn't it

borg · Post by **borg** » Mon Mar 14, 2005 11:42 am

yes, this is a very nice feature... people having a go at this, and want to save their work should be aware: if you take small snippets from (a) very long sample(s), be sure to consolidate/render the small pieces of audio you use. otherwise you'll end up with quite a large impulse project. (Live doesn't take the 'hits' you selected as the impulse sounds, but rather the complete file(s) you took the sounds from).
just a warning.

conny · Post by **conny** » Tue Mar 15, 2005 10:08 am

Yea, warning needed.
I just found that this use of clip settings goes for Simpler too.
Every day comes with new insights.
Live is deep... life is short...

// C