The clip settings make the LED on my BCR2000 shut off after one rotation of a loop (I assume it is because the MIDI note drops below 64). I need to keep the lights on.
Any one know what can be done?
Thanks a bunch,
Xris
MIDI settings, change?
-
xristopher
- Posts: 18
- Joined: Thu Dec 10, 2009 5:39 pm
- Location: Adelaide, AU
- Contact:
MIDI settings, change?
Can the midi messages that Ableton sends to a controller be changed?
The clip settings make the LED on my BCR2000 shut off after one rotation of a loop (I assume it is because the MIDI note drops below 64). I need to keep the lights on.
Any one know what can be done?
Thanks a bunch,
Xris
The clip settings make the LED on my BCR2000 shut off after one rotation of a loop (I assume it is because the MIDI note drops below 64). I need to keep the lights on.
Any one know what can be done?
Thanks a bunch,
Xris
“Its rhythms were out of stride and seemingly arbitrary. It’s drummers; frozen faced introverts, dedicated to chaos.“ -Ralph Ellison
xri§—†•ph€r the drummer
xri§—†•ph€r the drummer