Re-trigger clip with different quantize than start quantize

[LamptonWorm]

Hi,

Is it possible that if a clip isn't playing, and you set it to play, that it follows global quantize, but then if you re-trigger that same clip, it uses 'local' or per-clip quantize, i.e. a different quantize.

The reason I'm asking is to get an effect where the first launch of a clip is always "in time" and subsequent re-triggers start immediately, until it is stopped, then we are back to the "in time" launch.

Any ideas?

Cheers
LW.

[Warrior Bob]

So you want to trigger a clip on time, and then trigger it again multiple times against itself? Or perhaps you want to do a st-st-stutter effect?

You might try resampling your clip and loading that into Simpler or something?

[0fps]

You can change its Launch settings on the fly or to have two or more instances of the clip, with different launch quantization settings.

[LamptonWorm]

Hi,

Thanks for the ideas. I think two clips with different quant is what I'll end up with.

Cheers,
LW.

[Warrior Bob]

You can change its Launch settings on the fly or to have two or more instances of the clip, with different launch quantization settings.

I had totally forgotten that you can do this. Thanks for the reminder, 0fps!

[LamptonWorm]

Hi,

Are there short-cut keys to change the launch mode btw?

Cheers,
LW.