trigger cc

zizi · Post by **zizi** » Thu Jun 02, 2005 9:23 am

I have a question about the bcf2000 and clip launching.

If you have a triggered clip (not a toggled one), how do you setup a button on the controller it always reflects the state of the clip?

I've searched a bit, tried somewhat everything possible, but only ran into problems. For instance: if a clip is triggered by cc 20, then stopped with the "stop all clips" cc 21, how does cc 20 know that it stopped? live only sends the cc 21, it doesn't send the cc 20 off.

Anyone figured this one out?