ableton as Master, I lose 2 bars ...

Penfold · Post by **Penfold** » Wed Jun 01, 2005 9:19 pm

Hi ,

When ever i have ableton as master and syncec to my MPC, it starts from the begining fine 0.0.0, but if i need to go to a specific point on ableton live 4 it jumps back 2 bars on the MPC then plays from that time instead of the time i have moved it too.

I need it to snyc properly, I know its not a MPC problem cause it works fine in logic, cubase and protools. is this a bug with ableton?

mobonix · Post by **mobonix** » Sun Jun 05, 2005 6:25 am

I'm not sure if this will help...but since no one else posted i'll take a shot at it...

To work around this you should play with the midi latency settings to start recording after 2 bars.

I'm guessing ur using midi to trigger your MPC sequencer to start record sounds from the MPC into Live?

Penfold · Post by **Penfold** » Tue Jun 21, 2005 12:01 pm

tried this before i posted, and it does not work. this seriously a bug.