CORPUS audio effect LFO sync problems

[dese90]

Hi,

I'm experiencing some unwanted issues regarding the CORPUS effect.
What I have is an audio clip, recorded from my guitar. I've put it in the Arrangement view and added a CORPUS effect.
I picked the preset 'Drum to Bass' and did some changes.

Here are two files, the first one 'clean' : without the CORPUS on. The second with CORPUS.
(YES it's lo fi, recorded using Macbook pro built in mic and awful LINE 6 SPIDER III amp)

CLEAN: http://www.box.net/shared/14r7qdgvfg
CORPUS: http://www.box.net/shared/q68erbkvtv

So I've you listen to the CORPUS track, you hear the corpus giving an LFO delay 'beep' that I set at 1/2 rate, wich ends around half of the track (I automated the Wet parameter to make it fade out at half).
This is what I want. But sometimes, like if I start playing my arrangement view from 1 bar earlier, the LFO doesn't go in sync. This also sometimes occurs after exporting my live set. (This time when making the preview, I guess I got lucky because it is in the 1/2 sync). I was wondering how to make it set so that it always

This is a screenshot of the CORPUS settings:
http://i53.tinypic.com/2dl7pts.png

I hope this is clear..
Thanks in advance.

[dese90]

I've found a temporarily solution, wich is to export it to an audio clip and use it that way...
But i would still like a real know-how, since there must be one.

[zeepster]

In my experience Corpus effect often drifts. I can have Corpus sit on a track, save the arrangement, load it up, now the effect from Corpus sounds a bit different. Then most time when i move a specific knob the initial pre-save sound will be back.

I aways bounce the track with Corpus.