Automating start end points on Sampler / Simpler?

buckman · Post by **buckman** » Fri Jun 17, 2011 8:43 am

Is this possible?

I would like to map the start point of the Sampler and/or Simpler with a usb keyboard knob but even clicking on the value, I can't seem to map this to hardware to turn the start/end points live like a hardware sampler?

Is this possible or is there a work-around?

Slightlydelic · Post by **Slightlydelic** » Fri Jun 17, 2011 9:37 am

put the sampler/simpler into a rack mack the peramiters to the racks macros, map the macros to the controler knob.

UncleAge · Post by **UncleAge** » Fri Jun 17, 2011 10:14 am

...and don't forget to set "Remote" to "On" in the midi preferences for your usb keyboard.

pale1 · Post by **pale1** » Fri Jun 17, 2011 12:34 pm

Unfortunately, you can only do this in simpler.

Cheers

Automating start end points on Sampler / Simpler?

Automating start end points on Sampler / Simpler?

Re: Automating start end points on Sampler / Simpler?

Re: Automating start end points on Sampler / Simpler?

Re: Automating start end points on Sampler / Simpler?