I'd like to give him individual dry instrument tracks, AND also tracks that have the reverbs, delays and sidechain compression added.
I have set up my session with Delays and Reverbs on Sends, and I have a bus that receives signal from 5 tracks and sidechains it with the kick drum.
If I use Live's Render all tracks feature I get all the reverb data from every track is mashed together in a track called 'Send A' (same thing with the delays) and I get a track called 'Bus' which contains all 5 tracks of audio; sidechained nicely, but again, all mashed together in a single AIF.
Is there a way to separate out bus and send effects so they get printed to their individual tracks in render, or at least rendered separately rather than getting lumped together in their own audio file?
Surely this must be an important feature for people who want to tweak their reverbs for individual instruments in a mix, or work on a track with a lot of sidechaining.
As a workaround I tried copying my Sidechain compressor onto every track that was previously being sent to the sidechain bus, however, because the tracks were previously being effectively mixed down (to the bus) THEN sidechained to the kick, the volume changes were quite different when I put a sidechain on each individual track - ideally i'd rather not have to go through and tweak the individual thresholds on every tracks sidechain compressor, although I will if that's the only way to do this.
Suggestions?
Cheers, K