http://youtu.be/ViiJC91RaYc
if u watch the above vid.. you can see that my 'scene trigger button' is playing the same clip as what is assigned to the MPD pad... i want it on the MPD but not on the APC...
How do I undo this? Ive looked in the MIDI assign side panel but can't see anything...
Please help its driving me nuts ;p
pls help with my APC mapping - I've done something daft :)
Re: pls help with my APC mapping - I've done something daft :)
I think I've been able to resolve similar problems as follows:
1) Remove both devices from your computer.
2) Launch Live and disable both devices in your "Preferences" panel (i.e., control-comma and then set the selectors corresponding to the devices to "None")
3) Exit Live.
4) Connect your MPD. Launch Live again.
5) Select the MPD in your preferences panel. Make sure the MPD works properly.
6) Exit Live again. Connect the APC, leaving the MPD connected.
7) Launch Live again. Select the APC in another row of the device list.
With a little luck, all will now be well.
1) Remove both devices from your computer.
2) Launch Live and disable both devices in your "Preferences" panel (i.e., control-comma and then set the selectors corresponding to the devices to "None")
3) Exit Live.
4) Connect your MPD. Launch Live again.
5) Select the MPD in your preferences panel. Make sure the MPD works properly.
6) Exit Live again. Connect the APC, leaving the MPD connected.
7) Launch Live again. Select the APC in another row of the device list.
With a little luck, all will now be well.