loud noise when rewired to Reason.

difference · Post by **difference** » Mon Jul 04, 2005 9:04 pm

This is mentioned in the Tips and Tricks forum, but it's definitely a bug/problem imo!

If I have Live playing in a loop with Reason rewired, sometimes when it reaches the end of the a loop, it's like Reason fires a "note on" message to every device in it's rack and then stops (Live carries on).

The noise is so loud I am actually concerned it could damage my ears / monitors!! Seriously hurt last time and left my ears ringing for a good few mins. It also means I would not actaully be able to use Live & Reason together Live.

The problem is it's intermittent, I can't see any pattern to when it is happening. I can have the same loop playing over and over again fine, but then all of a sudden, it'll happen.

Any solutions? Is this fixed in 5?

(I'm using Live! 4.1.4 and Reason 3 btw)

difference · Post by **difference** » Fri Jul 08, 2005 11:59 am

Have found out the problem was with Reason and not Live!

Fixed in the update for Reason (3.0.3)

prop's site wrote: Loud noise when playing back in Loop mode
When playing back an NN-XT patch with Loop activated on the transport bar, the NN-XT could in Reason 3.0 produce a loud transient noise at the loop end position. Fixed.

Thank f*** for that!