Push : how to control LFO when tempo-synced?

[yop44]

Hi,

for example using Analog, when trying to change LFO speed nothing happend. It shows values in Hz and does not apply because paramater is set on tempo-synced.

Is there a way to switch between Hz/tempo-synced?

[#1thelark]

I was having the same problem when working with an arpeggiator within a midifx-rack.
I had to map a macro to the arp rate twice in synced and free mode and another macro to the sync/free-mode button to be sure the rate-macro works in both modes... maybe you can do that too.

[yop44]

I was having the same problem when working with an arpeggiator within a midifx-rack.
I had to map a macro to the arp rate twice in synced and free mode and another macro to the sync/free-mode button to be sure the rate-macro works in both modes... maybe you can do that too.

Tks for the tip.
But it's not so handy since you can't group device and map controls with push...

[#1thelark]

Do it once an then save it as a preset.. Then you can open it from push.

[Jip]

Surely Ableton can come up with a fix for this? Still not working!!!

[TomViolenz]

Have you installed the community map for Lives devices?!
Everything is mapped there.
The thread for it is on the first page here.

[Jip]

Have you installed the community map for Lives devices?!
Everything is mapped there.
The thread for it is on the first page here.

No - I haven't - I will look it up - thanks

however I can only see one page on here, can you point me in direction of the thread please?

[TomViolenz]

It's called "Change the parameter mapping of Lives own devices in Push!" and literaly 5 threads below this one.

[Jip]

Gotcha - I will have a look - many thanks…

Very frustrating that Ableton haven't seemed to think this through properly.

I have NI Maschine and to be honest I think the mapping / workflow is far superior, with more or less everything accessible, quickly.

I know theres a learning curve, but basic controls missing is a major let down by a company the size of Ableton.