Default midi control channel 1 controller 10

Mbazzy · Post by **Mbazzy** » Tue May 06, 2003 10:47 am

Just wondered if somehow it would be possible to change this ... every time I want to assign a midicontrol to an attribute in Live , the 1/10 control gets assigned at first automatically , however this is also the controller definition for a totally different controller in my setup .

Couldn't this be set to eg. 0/0 or so ?

harb · Post by **harb** » Fri May 09, 2003 1:21 am

Mbazzy,

I am not sure if I understand completely.

When you click on a parameter in midi map mode, 1/10 shows as the assignment before you do anything?

If so it sounds like you have a stuck control. CC 10 is usually standard for the pan control. Your controller could be transmitting this control because it is stuck... What controller do you use?

harb

Mbazzy · Post by **Mbazzy** » Fri May 09, 2003 7:42 am

Yep, from the moment I click on eg. volume and don't do a thing with my controller ... Live [that's what I thought] sets it to 1/10 ... I'll check on the sw developer's side as well

My controller is .. well ... is released very publicly [as something different] but not released yet as well [I'm betatesting ] ... but very close [in my eyes ] to be the perfect Live controller ... and it's amazing no one ever thought about this earlier ...

harb · Post by **harb** » Fri May 09, 2003 7:58 am

Mbazzy,

I am not sure what you have.... must be an NDA involved...

All I can say is that I have personally seen this problem with many controllers, but mostly with the Oxygen 8. Controllers jumping all over the place....

harb

Mbazzy · Post by **Mbazzy** » Fri May 09, 2003 8:03 am

LOL .. no I have no NDA [check your (private) messages on the forum ] ... but the work isn't enrtirely ready yet ...

harb · Post by **harb** » Fri May 09, 2003 8:21 am

Mbazzy,

So do you think it is a jumpy controller?

harb