Clip will only record for 1 bar then start to loop

rmacgregor · Post by **rmacgregor** » Sat Mar 29, 2014 4:46 pm

When I record a clip (midi or audio) in session view it will record for 1 bar then start to loop. I can't get it to record a longer clip. What setting need to be changed so I can record clips as long as I want? I'm sure this is something simple but I just can't figure this out.
I have:
Default Launch mode set to Toggle
Default Quantization set to Global

yur2die4 · Post by **yur2die4** » Sat Mar 29, 2014 4:50 pm

How are you making the clips? Sometimes people double click. You should only need to tap a record slot once and it should begin recording for a long duration, until you trigger it again.

rmacgregor · Post by **rmacgregor** » Sat Mar 29, 2014 6:04 pm

Single click on computer or trigger with FCB1010. It had been functioning okay.

chapelier fou · Post by **chapelier fou** » Sat Mar 29, 2014 6:06 pm

could you set your global quantification to 2 bars and post the results ?

rmacgregor · Post by **rmacgregor** » Sat Mar 29, 2014 10:52 pm

okay I figured it out. I had Touchable running too and fixed length clip had been enabled. Thanks for the suggestions.

chapelier fou · Post by **chapelier fou** » Sun Mar 30, 2014 9:33 am

Clip will only record for 1 bar then start to loop

Clip will only record for 1 bar then start to loop

Re: Clip will only record for 1 bar then start to loop

Re: Clip will only record for 1 bar then start to loop

Re: Clip will only record for 1 bar then start to loop

Re: Clip will only record for 1 bar then start to loop

Re: Clip will only record for 1 bar then start to loop