hello folks,
i have an urgent question — and i'd be really really gracious if anyone could help out.
when i sequence a clip with my push controller (meaning i have an empty slot and start its recording by programming a sequence on push),
the very first beat of this clip is always skipped (the very first time)... as if the step / note would arrive "in ableton" later than the command to
actually start playing the clip.
any clue?
thank you.
push skips first beat / step
-
- Posts: 556
- Joined: Fri Jun 25, 2004 3:18 am
- Location: Augusta, GA USA
- Contact:
Re: push skips first beat / step
Yes. I've posted about this and emailed tech support. Doesn't seem like anyone really cares. It makes Push unusable for me.
iMac, MacBook Pro, Live Suite, Reason, Logic Pro, Melodyne, FL Studio, iConnect Audio4+, Little Martin, ukelele, Greco gtrs, pedalboard, amps, mics .
http://www.soundcloud.com/gradynickel
http://www.soundcloud.com/gradynickel
Re: push skips first beat / step
good to know :/
i'll do the same and let you know if anything comes up.
i'll do the same and let you know if anything comes up.
Re: push skips first beat / step
i had the same problem. in my case i just had to quantize the steps then it worked.
-
- Posts: 20
- Joined: Tue May 31, 2011 3:59 am
Re: push skips first beat / step
happening to me too. quantizing is irrelevant
Re: push skips first beat / step
same here.. i've written ableton and sent them a status report —
apparently they'll be looking in to the problem.
keep our fingers crossed. damn :/
apparently they'll be looking in to the problem.
keep our fingers crossed. damn :/