User mode not working :(

[Arnerd]

I spent the last 5 hours writing a mapping for my push in Traktor
It all worked nice. I exported my mapping and restarted Traktor, and all was ok.
Then i switched off user mode, it asked me to browse for device, but there was no response from browse button. I shut everything down, restart push, it showed me the colors on the leds of my mapping in traktor for a short moment and then i got into ableton mode, i hit user-mode, and the lights stay off ... No reaction from buttons either, also not when trying to add a line to the mapping ... And the mapping is still there ... Also when i load a well known tsi file for traktor mapping, no response ...

Used to work great ... Al i did was upgrade the firmware today ...

[Mr.415]

The main issue here is that there's no existing command to refresh leds in traktor at the moment, so unless you press a button, Traktor isn't going to be asked to send all the led signals to bring up the led mapping.