UC-33 QUESTION (and/or General Midi)...

emz · Post by **emz** » Fri Aug 19, 2005 6:53 am

I'm too lazy to dig through the manual and was curious to see if others could help me out w this quesiton. It doesn't really matter whether with the UC-33 or not, but my question is, how would you go about setting a knob on a controller to, for instance, launch a clip in a track by panning above 64....and/or stop a clip by panning below 64??? I'd really appreciate any and all help on this one fellas...

Regards...

Emz

Machinate · Post by **Machinate** » Fri Aug 19, 2005 7:29 am

set the loop to gate mode, enter the midi assignment mode, select the loop, and then turn the knob.

Clearscreen · Post by **Clearscreen** » Fri Aug 19, 2005 7:50 am

i used to trigger clips with a doepfer pocket dial this way, and it worked surprisingly well! i had the clips set to relative, so a positive turn launched em, and a negative one stopped em. now i use buttons, and i'm not sure it's particularly better...

emz · Post by **emz** » Sat Aug 20, 2005 6:59 pm

thx for the advice fellas. it's much appreciated...