I record a two bar loop on Push 2, then I hit the record button again to stop the loop. However, Ableton always creates an 3rd bar because I’m not fast enough for it to think I only wanted 2 bars. Is there an option to adjust the allowed delay-period?
I feel that I hit the button pretty quickly (see video), and I swear I never had this issue with Push 1. Did Push 1 allow more of a delay?
https://dl.dropboxusercontent.com/u/839 ... oopRec.MOV
Push 2: Too short of period when stopping clip-record for it
-
jcarlson0320
- Posts: 7
- Joined: Fri Apr 15, 2016 8:02 pm
Re: Push 2: Too short of period when stopping clip-record for it
Not sure about the delay period, but can you just use the "fixed length" mode to make your loop two bars long?elgrayso wrote:I record a two bar loop on Push 2, then I hit the record button again to stop the loop. However, Ableton always creates an 3rd bar because I’m not fast enough for it to think I only wanted 2 bars. Is there an option to adjust the allowed delay-period?
I feel that I hit the button pretty quickly (see video), and I swear I never had this issue with Push 1. Did Push 1 allow more of a delay?
https://dl.dropboxusercontent.com/u/839 ... oopRec.MOV