pops when swapping channels on push 2

[DrTroutHair]

Hi Folks,
As the title would suggest, I've a single pop or click coming through the monitors each time I swap tracks to make adjustments whilst audio is running.
So if I tweak track one the on Push then select track 2 on Push I get a single pop. It coincides with the red square flashing to indicate a midi signal being sent.
Even if I use my key board and mouse to select a different track I get the pop. However, if I switch Push off and switch tracks I don't get the pop.
I'm sure this must be a common problem with a simple fix but I didn't find anything with a quick search.
Any ideas?
Cheers

[[jur]]

It is due to the auto-arm behavior.
Try changing the "clip update rate" or whatever it is called in the Preferences to a higher value.

[NoSonic822]

i had this problem a long time ago, it happens when you have the reduced latency on, and you have auto arm on....

[[jur]]

You're right about the reduced latency when monitoring Inversoundzzz.

[DrTroutHair]

Thanks folks - I'll look into auto-arm etc.
Just to update though - after shutting down and rebooting a few hours later the effect wasn't there any more.