As of today, Push has started launching the previous/next scene when I press up/down arrows to change octave while in NOTE mode. The octave is also not getting changed as expected. All other Push functions are working fine and up/down arrow are scrolling through the scene as expected in SESSION mode without launching them.
Thing's I've tried to figure out the problem:
- Switching push to "clip" workflow instead of "scene" does the same, but to the the first track only.
- Disabling remote in midi settings doesn't change anything. Push is also the only connected midi device.
- There are no midi/key binding in my project (I have the same issue if i start from a blank project)
- A look through midi monitor shows CC 46 and 47 as the one being transmited by the arrow up/down tap in note mode
Did anyone ever had that problem? I could not find anything about this online. I'm sure that it's super obvious but I just can't figure out the root cause...
I'm using Push MK1 and Live 9.7