MPK mini

aklisiewicz · Post by **aklisiewicz** » Thu Feb 04, 2021 10:20 pm

I want to replace original knobs on my MPK-Mini with something more reliable and slightly bigger. Any idea what would fit ?

jynx3d · Post by **jynx3d** » Sat Feb 06, 2021 2:35 am

Hi pal, I've always wanted to change my old mk1 MPK mini style, the best solution are finding a 3D printing service near or online with sending them a picture of the size of the knob and the D shaped hole fit with ruler.

aklisiewicz · Post by **aklisiewicz** » Fri Feb 19, 2021 2:37 am

ordered one set from amazon but it didn't fit. Waiting for another one . Will share if it fits well

jynx3d · Post by **jynx3d** » Wed Feb 24, 2021 8:18 pm

send the knob to local or online 3d print service, they will do their job

aklisiewicz · Post by **aklisiewicz** » Wed Feb 24, 2021 11:24 pm

I have already found knobs on Amazon. I had to trim them though but it was only a 15 min job with wire cutter and piece of sand paper. It is not perfect but way much better than stock junk.

https://www.amazon.com/gp/product/B07JM ... UTF8&psc=1
Basically I had to trim the bottom part (black) to flash with the white insert. It was quite easy to do.

MPK mini

MPK mini

Re: MPK mini

Re: MPK mini

Re: MPK mini

Re: MPK mini