Help-Audiointerface Push2 LIVE

[thms rthmr]

Hello dear forum,
i use a
windows notebook
a Focusrite Scarlett 2i2 2nd Gen
and the Push2


Now to my question:
I would like to use Push2 as a live instrument with my band. We have already tried to practice with it in the rehearsal, but we have to let everything on the system and on the audio interface run to almost full volume.

Is there a way to amplify the signal? Or is it maybe because of my "cheap" audio interface?

Thanks for the help

Thomas Reithmeier

[jestermgee]

Is there a way to amplify the signal?

'

An Amplifier?

You haven't explained what your computer audio is output to. You have an audio interface already, but what does that connect to and what does your band connect to?

If you have guitars/drums/live instruments then your laptop will need something it connects to to make physical sounds (speakers) which will be amplified somehow. What is the speaker/amp setup you currently have? Typical laws of physics if you want more sound, amplify the signal more and if you cannot push large enough waves from the speakers, bigger speakers will push bigger waves

[thms rthmr]

hey
jestermgge thanks for the quik answer.

this is our music system: https://www.thomann.de/de/ld_systems_dave_12_g3.htm
and that is our mixer: https://www.thomann.de/de/yamaha_mg16xu.htm
I go out of my audiointerface (Focusrite 2i2), and then with the left and right TRS jack plug into the mixer and from there into the aktive speakers.

is there a way to amplify the audio signal from the audiointerface.


or is the signal of the audiointerface already amplified or not