Push 3: Can't change headphone volume
Push 3: Can't change headphone volume
Anyone else see this? Clicking the master volume encoder doesn't change the outputs for me. I can just change the main outs, not headphone volume.
Re: Push 3: Can't change headphone volume
Same here with the controller Version of push3.
Re: Push 3: Can't change headphone volume
Don't forget that Cue and Headphones aren't necessary the same depending on your setup. Just saying as I personally remember being confused a few times.
Ableton Forum Moderator
Re: Push 3: Can't change headphone volume
Yep - but pressing the volume encoder does nothing. I can’t select different outputs at all to change volume.
Re: Push 3: Can't change headphone volume
Oh, ok...
Did you update it too v1.1, or are you still on the factory version?
Ableton Forum Moderator
Re: Push 3: Can't change headphone volume
I've noticed that it doesn't show on the screen when the screen is on certain things. I will try to recreate it. It would still raise and lower the volume but you couldn't see which volume you were raising.
Re: Push 3: Can't change headphone volume
Yep on 1.1. Did. A factory reset and problem is still there. I sure hope my hardware isn’t broken
-
- Posts: 20
- Joined: Sat May 27, 2023 4:22 pm
Re: Push 3: Can't change headphone volume
You have to press the encoder down to change it to headphone
Re: Push 3: Can't change headphone volume
He already said pressing the encoder does nothing...
-
- Posts: 20
- Joined: Sat May 27, 2023 4:22 pm
Re: Push 3: Can't change headphone volume
he said click? edit - also seen he said pressed
Re: Push 3: Can't change headphone volume
It only clicks when you press it
BTW did any else fail to get the startup tutorial when first powering up their Push?
The first thing mine did was display that "unexpectedly quit" message about recoving a previous project. It was fresh out of the box! Then apparently it's supposed to go to the welcome screen. Mine didn't do that.
BTW did any else fail to get the startup tutorial when first powering up their Push?
The first thing mine did was display that "unexpectedly quit" message about recoving a previous project. It was fresh out of the box! Then apparently it's supposed to go to the welcome screen. Mine didn't do that.
Re: Push 3: Can't change headphone volume
That for sure is surprising, but it is working now, right?
Make sure to update to v1.1 asap. The factory software version isn't stable enough.
Ableton Forum Moderator
Re: Push 3: Can't change headphone volume
Yes, I updated immediately after connecting to wifi, and it seems to be behaving itself now.
I quite like the automated file naming when saving
I quite like the automated file naming when saving
Re: Push 3: Can't change headphone volume
I have the same problem, it only changes if i push down a lot harder and hold for about 2 seconds and let go. It was instant the first few times I switched between them. I updated to 1.1 before this even started happening
Last edited by cjonesnyc on Tue May 30, 2023 4:19 pm, edited 1 time in total.