Push 2 knobs and Macro steps

[nrgskill]

Hi, I've been using and enjoying Push 2 for years, but always struggled whit this one little thing:
I create libraries of sounds using Sampler and skipping through each sound by assigning a Macro to the Sample Selector.
If I have 128 sounds (0 to 127), each assigned to a step of the sample selector, when I move the Push 2 knob, I see the number changing, but the sound doesn't change until I move it a little bit more. It's like for the macro 0 - 1 - 2 - 3 the samples switch at 0 - ~1,5 - ~2,5 - ~3,5.
Hard to explain and very annoying.

Any advice please?

[[jur]]

Yeah this is a known issue.
I'm afraid the only thing you can do atm is to report to Support; the more reports they get, the more it gets prioritise.