Help: Push 3 Standalone Connecting to RME 400 via ADAT

[SPIRITWORLD]

I just got a Push 3 standalone and i'm trying to run ADAT out of the Push to the ADAT input of the RME 400 so I can run a small mixing board live with individual tracks from the Push.

I believe the issue is with the RME, as the track routing & Push settings etc are all set up. I have checked the saved RME settings and both units are at 48000. The RME is set to Master etc.

I know each sound card is unique when it comes to ADAT etc. Does anyone have experience with running Push 3 and RME 400 / 800 via ADAT.

Tips would be appreciated!

[silentio246]

I have no experience with Push/Adat, but logically it is a question of master and slave. When you send Push Adat Out to RME 400 Adat In , Push has to be the master. Otherwise connect both ins and outs, that Push gets Adat Sync from RME.

[SPIRITWORLD]

Thanks for this. I have tried setting the RME to both master and slave and have connected both the in and out adapt inputs on both devices, as I hear that some units required ed a two way connection. Unfortunately, neither has worked.

[silentio246]

Actually ADAT should work when properly configured, unless there is a defect. It is audio standard for long time. Maybe you should ask in the RME forum: https://forum.rme-audio.de/

[SPIRITWORLD]

Bumping this up! Please help. I took a long break from trying to sort this out and i've come back with a fresh brain but the same issue persists.

I'm running both ADAT in and out of a RME 400.

Push 3 is recognizing the unit as "ADAT IN" lights up and the sample rate changes.

However, for the life of me I can still NOT get the audio to come out of the Push 3 Standalone to the RME on any channels.

Any help would be appreciated!

[silentio246]

Did you select the right ADAT output in Push?
Can you see audio coming into the RME on the TotalMix software?
TotalMix is very versatile.