Push 3 and noise interference

[beebeeveevee]

Hi there

I've been having problems with signal input quality on my P3S. I find that there is what sounds like RF interference - humming, crackling and other strange noises. It seems extremely sensitive to everything near it.

The worst offenders seem to be the P3S power supply - if it is plugged in, I get constant hum when monitoring, and also when I touch any controls - each control I touch will trigger a buzzing sound when I am monitoring.

I also find that the signal input carries noise and interference too. Some of this might be the gear that I use (I'm aware than single coil pickups are very sensitive, and I use some vintage gear such as tape delays which can also create noise) but I'm broadly familiar with different types of noise interference and this seems to be emanating primarily from within the Push.

Does anyone have any tips / ideas?

[Tarekith]

Are you using the USB-C cable that came with it?

[beebeeveevee]

No - nothing is connected via USB-C - I'm in standalone. I have connected things to the USB-A port but also have to unplug those when recording audio to remove buzz and interference.